IEC60335-1 Clause 14 High Voltage Impulse Generator Voltage Waveform Peak 0.2~12.5kV

IEC60335-1 Clause 14 High Voltage Impulse Generator, Voltage Waveform Peak 0.2~12.5kV

The high voltage impulse generator generates high voltage impulse during operation. For your safety, please read this manual and use the device correctly. Please pay attention to the following points during use:

(1) Do not use the device when the hands are wet or the relative humidity exceeds 75%.

(2) Since a high voltage impulse is applied to the terminal (Surge out), if want to change the wiring, it is necessary to confirm that the high voltage power supply is off (the HV.POW lamp is off).

(3) The operation must strictly follow the instructions for use.

(4) Do not eat during operation to prevent accidental food blockage caused by electric shock.

(5) This equipment uses a vacuum contactor to generate voltage impulse. In order to ensure the life of the vacuum switch, do not turn on the high voltage when the equipment is not tested. In particular, do not continuously trigger the vacuum contactor under high pressure.

(6) With high voltage inside, do not disassemble or open the case. IEC Test Equipment

Standard: Conforms to IEC60335-2-6 clause 14,clasue 16,IEC60335-2-9 clause 14,IEC60335-1 clause 14, IEC 60950-1:2013 clause 2.10.3.9, reference 2 of table N.1 and etc., IEC 60898-1 clause 9.7.

Feature:

7-inch touch LCD interface, rich in functions, easy to operate, easy to upgrade software IEC Test Equipment

Intelligent programmable high voltage power supply, built-in high voltage over voltage, over current and short circuit protection

Output intelligent detection, voltage error, no output warning

Parameters:

Pulse generating unit equivalent circuit:

Output waveform definition Voltage wave

Leading edge time: T1=1.67T=1.2μs±30%

Half-peak time: T2=50μs±20% IEC Test Equipment